AUTOPLAY
XL Wood Board For Painting. Step By Step
8 steps
What you’ll need
1
Sliding Compound Miter Saw
Buy
1
Drill
Buy
Plyw
1
Circular Saw
Buy
1
Corner Cat Sander
Buy
1
Wood Glue
5
2x4
1
Kreg Jig K4
Buy
Kreg Pocket Hole #8
I used my Circular saw to cut two pieces of plywood and created a 5'x6' board.
1. I used my Circular saw to cut two pieces of plywood and created a 5'x6' board.
1
I cut the 2x4s with the Miter saw to create the frame.
2. I cut the 2x4s with the Miter saw to create the frame.
2
The Kreg Jig is perfect for creating holes to connect the frame.
3. The Kreg Jig is perfect for creating holes to connect the frame.
3
After gluwing the 2x4s I Screwed them to each other with the Kreg pocket hole screws.
4. After gluwing the 2x4s I Screwed them to each other with the Kreg pocket hole screws.
4
I left it in the sun for a few hours to dry.
5. I left it in the sun for a few hours to dry.
5
I used the Corner Cut Sander to sand the whole board.
6. I used the Corner Cut Sander to sand the whole board.
6
Now it's ready! I covered it with a white primer before painting.
7. Now it's ready! I covered it with a white primer before painting.
7
Have fun with your project. Thanks !
8. Have fun with your project. Thanks !
8