AUTOPLAY
Lofty with Flat Clad To Cornubia Clad & Doors
18 steps
Switch off lights and Remove fluorescent lights and night blind
1. Switch off lights and Remove fluorescent lights and night blind
1
Remove top canopy by in-screwing the fixing screws on top of the case
2. Remove top canopy by in-screwing the fixing screws on top of the case
2
Remove joint trim
3. Remove joint trim
3
Remove top cover plate
4. Remove top cover plate
4
Switch anti sweat and light breaker off and disconnect temp display/controller power supply
5. Switch anti sweat and light breaker off and disconnect temp display/controller power supply
5
Remove the display/controller and disconnect the power supply
6. Remove the display/controller and disconnect the power supply
6
Double check that no power is live to the switch
7. Double check that no power is live to the switch
7
Connect female bullet connector onto the light circuit breaker
8. Connect female bullet connector onto the light circuit breaker
8
Remove screws that hold light house in place
9. Remove screws that hold light house in place
9
Hold the light before loosening last screw
10. Hold the light before loosening last screw
10
Carefully remove light house
11. Carefully remove light house
11
Remove small top hat
12. Remove small top hat
12
Strip the case to this point
13. Strip the case to this point
13
Connect slave to master
14. Connect slave to master
14
Make sure to line the top canopies up.
15. Make sure to line the top canopies up.
15
Fit leds and doors
16. Fit leds and doors
16
Adjust Doors
17. Adjust Doors
17
Clean area and make sure all doors are adjusted
18. Clean area and make sure all doors are adjusted
18