How toMake Pixar’s Slinky Mickey Ears
18 steps
What you’ll need
Light Brown, Dark Brown, White, Black
4 pieces of felt
Polyester Filling
Hot Glue Gun
Brown Beaded Trim
Black Headband
Mouth, Nose, Eyes, Eyeballs, Ears, (Eyebrows/Eyelids), Head, Body
Sketched Template
Leprechaun Green Ribbon
Scissors
Aluminum Wire
Cut out your template pieces to begin! You can always wing the shapes during the process.
1
Place your ear template over the lighter brown felt and cut the shape 8 times!
2
Now grab the white felt for the mouth! Snip Snip Snip✂️
3
Gotta let this pup hear his slinky noise! Cut out two ears with the dark brown felt!👂🏼
4
Now for the eyes! White: Eye-Shape, Black: Eyeball, Light Brown: Eyelid, Dark Brown: Eyebrow.
5
Grab your glue gun and begin to glue the ear together in sections, leaving the bottom open.
6
Now grab the filling and being stuffing until fluffed.
7
Glue the bottom shut!
8
Time to put it all together! Glue both ears to the band while leaving a few inches open between.
9
Chose your favorite ear to make into Slinky Dog’s face! Then glue down the mouth.
10
Time for ears! Only glue half way down the inside section of each ear.
11
Make sure each felt shape for the eyes are in pairs. Then glue away!
12
Make sure the snout is on nice a tight!
13
Slinky Dog’s eyebrows are on FLEEK!
14
Glue the brown beaded trim section by section, shaping the other ear to create the booty.
15
Who’s Slinky Dog without the Slinky? Wrap the aluminum wire into a slinky form for the body.
16
Glue it down, and then make the collar by placing the green ribbon on the 1st spiral.
17
Finish it off by making a shorter slinky that starts with bigger spirals for the tail.
18
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18