AUTOPLAY
How To Make A Entryway Bench
32 steps
Hello!
What you’ll need
Birch Plywood
Reclaimed Lumber
Moulding
1x3 Pine Board
Rip the top and bottom of the base
1. Rip the top and bottom of the base
1
Cut the vertical supports
2. Cut the vertical supports
2
Using a stop block, cut them to length
3. Using a stop block, cut them to length
3
Glue and then attach using screws
4. Glue and then attach using screws
4
Flip upright and repeat
5. Flip upright and repeat
5
Glue and attach the back
6. Glue and attach the back
6
Nail it
7. Nail it
7
Rip the trim for the side profile
8. Rip the trim for the side profile
8
Cut to length
9. Cut to length
9
Glue and attach to sides
10. Glue and attach to sides
10
Attach the horizontal trim
11. Attach the horizontal trim
11
Then the vertical
12. Then the vertical
12
Cut the moulding to length either straight or at 45 degrees
13. Cut the moulding to length either straight or at 45 degrees
13
Glue and nail the moulding
14. Glue and nail the moulding
14
Same for the side
15. Same for the side
15
Attach base supports
16. Attach base supports
16
Paint the base using a sprayer
17. Paint the base using a sprayer
17
3 coats should do it
18. 3 coats should do it
18
Now for the top. Cut your reclaimed lumber roughly to length
19. Now for the top. Cut your reclaimed lumber roughly to length
19
Check for nails, then create a flat bottom over on the joiner
20. Check for nails, then create a flat bottom over on the joiner
20
Same for one edge
21. Same for one edge
21
Place the flat edge against the fence and cut to width
22. Place the flat edge against the fence and cut to width
22
Send through the planer, flat side down
23. Send through the planer, flat side down
23
Mark where the biscuits will go
24. Mark where the biscuits will go
24
Cut slots w/ biscuit jointer
25. Cut slots w/ biscuit jointer
25
Add glue and biscuits...then press together
26. Add glue and biscuits...then press together
26
Square off the ends
27. Square off the ends
27
Add stain
28. Add stain
28
Start with a sealer then wipe on poly
29. Start with a sealer then wipe on poly
29
Mount the top to the base
30. Mount the top to the base
30
Add baskets of your choice
31. Add baskets of your choice
31
Place in the entryway and you are done! Please subscribe for more videos :)
32. Place in the entryway and you are done! Please subscribe for more videos :)
32