AUTOPLAY
How To Layer HTV
8 steps
What you’ll need
Starcraft Softflex
Buy
Starcraft Heatpress
Buy
Pin Pen
Buy
Cut out your design on your HTV (dont forget to mirror)
1. Cut out your design on your HTV (dont forget to mirror)
1
Weed your design
2. Weed your design
2
Place your design. Dry fit your layers
3. Place your design. Dry fit your layers
3
Set your heat press to the temp, time, and pressure for your HTV.
4. Set your heat press to the temp, time, and pressure for your HTV.
4
Press your first layer for just a few second to tack it down. Remove carrier sheet.
5. Press your first layer for just a few second to tack it down. Remove carrier sheet.
5
Place layers that do no overlap and press just a few seconds to tack.
6. Place layers that do no overlap and press just a few seconds to tack.
6
Remove all the carrier sheets.
7. Remove all the carrier sheets.
7
Add your final layer and press for the entire time required by your HTV
8. Add your final layer and press for the entire time required by your HTV
8
Enjoy your final project!