How toBuild A Large Photo Booth Frame
14 steps
What you’ll need
5
10’ PVC Pipe
6
3/4” PVC Slip Tee
Pencil
1 1/4” PVC Pipe Cutters
2
3/4” PVC Slip 90 Degree Elbow
1
3/4” PVC Slip Cross
Tape Measure
Measure your floor to ceiling- you need 90” (if smaller, decrease the 48” measurements to fit)
1
On a PVC pipe, measure out 48” and mark - you will need 7 of these pieces (using 3.5 PVC)
2
On remaining pipe, measure out 36” and mark - you will need 3 of these pieces (using 1.5 PVC)
3
Cut along each of those lines using PVC cutters
4
You should have 24” to 48” left on each PVC pipe- measure and cut six 12” sections
5
You should have: six 12” feet, three 48” legs, three 36” legs, four 48” widths (top & bottom)
6
This is a visual of how the pieces will come together
7
Three bottom pieces: with the tee, connect the 12” feet on both sides with a 48” leg on the top
8
Two top L & R pieces: with the 90 deg elbow, connect a 36” leg on bottom with a 48” width on the top
9
One top middle piece: connect the top L and R with a tee in the middle of the 48” widths
10
Top middle: Add last 36” leg to your tee (all three 36” legs should be attached to this top section)
11
One bottom middle piece: connect two 48” widths to your cross on opposite sides
12
Bottom middle: connect one of your 48” bottom legs to the bottom of the cross (this will be big)
13
Connect the bottom middle piece to the L & R tees, add the whole top section- measures 8’W 7’H 2’D
14
1
2
3
4
5
6
7
8
9
10
11
12
13
14