What you’ll need
Cricut Easy Press Mini
Jump Ring + Earring Hooks
Hole Punch 1/16th Inch
Cricut Weeding Tool
Samantha Upright FontBuy
Design in DS. Hearts are from access images. Font is Samantha Upright. Link in supplies.
Duplicate: Four 2.25 in wide hearts for a front and a back. MIRROR the HTV mat.
Trim felt & HeatNBond to the size you’ll need to make the hearts. 3 inches by 10 inches.
Cut iron-on mat & apply HeatNBond to felt with EP Mini. Allow to cool before peeling off the back.
To cut felt: change material setting to “Felt, Craft Bonded” & change to Rotary blade.
Use scissors to carefully trim hearts out if needed & place them HeatNBond sides together.
Weed HTV design & align on top of double sided hearts. The heat will bond the 2 sides together.
Press on medium heat for 25 seconds & allow a few seconds to cool before removing the backing.
Replace clear film back over pressed designs, flip over, & press designs to the backs.
Allow to cool & remove all 4 backing pieces. (I used scrap felt over my mat. HeatNBond gets melty.)
Hole punch both hearts where you’ll apply the jump ring.
Use pliers to widen jump ring if needed & fish it through the hole. Add earring hook & close ring.
Thanks for watching!