What you’ll need
Faux Leather Wide Ribbon
Cricut Design Space
1 pair of scissors
Upload bow templates into DS and resize to your liking. Remove smaller bow piece for single layer.
Cut bows with Cricut. I used Light Grip Mat, Denim Heavy Fabric setting & Rotary Blade.
Lay out newspaper to protect surface & organize your bows. I wear gloves and respirator with E6000.
Cut panty hose and stretch to make headbands.
Apply light pressure to glue tube and apply with toothpick. Fold over to center and hold in place.
Holding bow with two fingers grab your bottom piece and apply glue then carefully transfer on top.
Keep holding pressure & grab smaller bow piece. Apply glue & layer on top. Fold to center and hold.
Apply glue to center & place long piece over bow. Switch pressure to each side of the long piece.
Apply glue to headband & transfer bow on top. Flip upside down. Glue each side of long piece & fold.
NEVER LET GO OF PRESSURE! Transfer bow face down under a flat heavy surface to hold in place.
Once dry fluff up each side of your bow. To make single layer bow omit the top smaller bow piece.