AUTOPLAY
DIY Chair Re-upholstery
13 steps
Hello!
What you’ll need
1 (I linked one with a remover)
Hand Stapler
Buy
1
Canvas Stretcher
Buy
Needle Nose Pliers
Phillips and Flathead
Screw Drivers
First thing unscrew your seat cushion from your dining room chair.
1. First thing unscrew your seat cushion from your dining room chair.
1
Remove any back paneling to reveal the staples.
2. Remove any back paneling to reveal the staples.
2
Remove staples holding the piping.
3. Remove staples holding the piping.
3
Tip
4. Tip
4
Finish deconstruction mode and clean up!
5. Finish deconstruction mode and clean up!
5
Layout fabric
6. Layout fabric
6
Tools for upholstery: stretcher, staple gun, staples
7. Tools for upholstery: stretcher, staple gun, staples
7
Tack the corners and then work back and forth from side to side and corner to corner.
8. Tack the corners and then work back and forth from side to side and corner to corner.
8
Pull the fabric with stretcher and staple. Always go back and forth pulling tightly. Reapply piping.
9. Pull the fabric with stretcher and staple. Always go back and forth pulling tightly. Reapply piping.
9
I always use scrap fabric for the underside.
10. I always use scrap fabric for the underside.
10
All done! Check for wrinkles.
11. All done! Check for wrinkles.
11
Screw cushion back on chair!
12. Screw cushion back on chair!
12
Voila, all done!! Give yourself a pat on the back! And then repeat for the entire dining set🥰
13. Voila, all done!! Give yourself a pat on the back! And then repeat for the entire dining set🥰
13
Thanks!