DIY Acrylic Keychains Using UV Resin
Made with 
I may earn commissions for purchases made through links in this video.
As an Amazon Affiliate, I may earn commission from qualifying purchases.
Acrylic Blank and Hardware
Buy
UV Resin
Buy
UV Lamp
Buy
Silicone Trivet Or Mat
Buy
Acrylic Blank and Hardware
Buy
UV Resin
Buy
UV Lamp
Buy
Silicone Trivet Or Mat
Buy
Medicine cup
Buy
Glitter
Popsicle Stick
Small Paint Brush
Buy
Safety Supplies
Vinyl Decal With Transfer Tape
Add UV Resin to the medicine cup. Next add glitter and mix.
1
Made with 
Peel the protective layer off the back side of your acrylic blank. Leave paper on the front side.
2
Made with 
Dab the glitter and UV Resin on the back of the acrylic blank. Then cure in UV Lamp for 60-120 sec.
3
Made with 
Add a second layer of glitter and UV Resin to build up the color. Cure in the UV Lamp for 60 seconds
4
Made with 
Next add a layer of plain UV Resin. Hit briefly with heat gun. Cure in UV Lamp for 60-120 seconds.
5
Made with 
Remove the protective sheet from the front of the blank. Apply your vinyl decal(s).
6
Made with 
Add a layer of plain UV Resin. Cure for 120 seconds for a thicker layer.
7
Made with 
Lastly, add the hardware. I added the dangle, blank, and then the key ring. Close the jump ring.
8
Made with 
You’re finished, great job!
9
Made with