AUTOPLAY
Cut Monster Bash Designer Paper With ScanNCut
12 steps
Hello!
Turn on machine and check blade (mine is set between 3 and 4)
1. Turn on machine and check blade (mine is set between 3 and 4)
1
After hitting the home button, select SCAN, DIRECT CUT, the machine icon then load the mat.
2. After hitting the home button, select SCAN, DIRECT CUT, the machine icon then load the mat.
2
Select the START button to scan and allow to process.
3. Select the START button to scan and allow to process.
3
Select OK to view the scan
4. Select OK to view the scan
4
If desired, add an outline of 0.04” and select OK to process
5. If desired, add an outline of 0.04” and select OK to process
5
Before cutting, I am deleting the images that didn’t scan completely.
6. Before cutting, I am deleting the images that didn’t scan completely.
6
Delete anything that will not cut properly and use the magnify function to view the cut lines
7. Delete anything that will not cut properly and use the magnify function to view the cut lines
7
When ready to cut, select CUT and the start button.
8. When ready to cut, select CUT and the start button.
8
It took about 4 minutes to cut this entire sheet.
9. It took about 4 minutes to cut this entire sheet.
9
Once cutting is complete, unload the mat and remove the paper from the mat.
10. Once cutting is complete, unload the mat and remove the paper from the mat.
10
My finished cuts. Peel back gently or use a spatula to remove die cut images.
11. My finished cuts. Peel back gently or use a spatula to remove die cut images.
11
Use your die cuts on any papercrafting project.
12. Use your die cuts on any papercrafting project.
12