AUTOPLAY
Advanced Cutting And Piercing In Ceramic
4 steps
after drawing design on clay begin to cut out design with xacto blade when clay is leather hard.
1. after drawing design on clay begin to cut out design with xacto blade when clay is leather hard.
1
As you cut through pull pieces out using the end of blade. Pul from corners to make this easier.
2. As you cut through pull pieces out using the end of blade. Pul from corners to make this easier.
2
Pull pieces out gently from top of piece to bottom so that pressure doesn’t crack lower levels.
3. Pull pieces out gently from top of piece to bottom so that pressure doesn’t crack lower levels.
3
Clean inside each hole by shaving and smoothing with blade, fingers, and sponge.
4. Clean inside each hole by shaving and smoothing with blade, fingers, and sponge.
4